Boot procedures for TRSKER
        --------------------------
 
 
A- The easy way.
 
        Get the TRSKER already on a TRSDOS (Model II) formatted diskette.
        (If you can't find it, send me an 8 inch diskette and I'll send 
        it back to you with TRSKER.)
 
B- The not so easy way.
 
        Get TRSKER.HEX on a PC.
        Connect the PC to the Model II using a direct link or a modem.
        Issue a SETCOM command to set communication speed on the Model II
        running TRSDOS.
        Issue a RECEIVE command on the Model II
        Issue a MODE command on the PC to set the communication speed.
        Issue a TYPE TRSKER.HEX > COM1: on the PC.
        Pray to your favorite metaphysical being for a good connection.
        Issue a DUMP command on the Model II to get your memory to disk.
 
C- The hard but fullproof way.
 
        Get TRSKER source code on a PC.
        Setup communication speed on the Model II using SETCOM.
        Execute TERMINAL on the Model II. 
        Open and reset RAM buffer.
        Enter terminal mode and watch the files go by.
        One after the other send the source files from the PC
        using TYPE TRSXXXX.MAC > COM1:
        After each file, on the Model II close the RAM buffer and
        write it to disk.
        Once your through with the transfer use the Microsoft assembler
        and linker for the Model II to produce an executable version.
 
M80     TRSMAIN,=TRSMAIN
M80     TRSDATA,=TRSDATA
M80     TRSMSSG,=TRSMSSG
M80     TRSRECV,=TRSRECV
M80     TRSSEND,=TRSSEND
M80     TRSUTIL,=TRSUTIL
M80     TRSUTIL2,TRSUTIL2
 
L80     TRSKER-N-E-M,TRSMAIN,TRSRECV,TRSSEND,TRSUTIL,TRSUTIL2,TRSMSSG,TRSDATA
 
 
        Happy Kermitting,
 
 
        Serge G. Kruk
        Systemes Temps Reel
        1030 Hodge
        St-Laurent
        Quebec, Canada
 
        H4N 2B7         (514) 748-0515